![]() This allows them to randomly nail baseboard trim into the bottom plates instead of a vertical wall stud. ![]() This is less accurate because in some places, rough carpenters install a double bottom wall plate. I’ll also look for poorly patched nail holes in baseboard. In these situations a special remodeling box is used that doesn’t need to be nailed to a wall stud. In rare instances, a particular wall outlet may have been added at a later date. In almost all situations, the boxes that house the outlets are nailed to the side of a wall stud. If the house is middle-age or newer, say built after 1950, I look for electrical wall outlets. The first thing I do when I have to find a stud is look for clues as to where they would be. It works well, and because I strategically drove the nail into the wall in certain spots, the cabinets covered the exploratory holes after they were hung. I reverted back to my old-fashioned method of a hammer and a nail. Just this past weekend, I had to find some wall studs to hang wall cabinets. You can see why using these tools requires a knowledge of building habits in certain parts of the nation. ![]() The builder’s rough carpenters had installed 1x3 furring strips across the entire ceiling at 90 degree angles to the floor joists. It turned out that the device was finding them, but that they were recessed from the surface of the backside of the drywall by 3/4 of an inch. We even had the house plans and knew the direction of the floor joists. It would indicate where a ceiling joist was behind drywall, and when you drove a nail, it wasn’t there. Two years ago, I was using a stud finder tool with a helper and it was giving all sorts of false positive signals. They are telling me where the center of the stud should be, it’s edges and the real center point. These symbols are not from a Mayan or Egyptian tomb.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |